Control Panels For Unclog Pumpsets, Control Panels For Dewatering Pumpsets, Control Panels For Hydro Pneumatic Pumpsets, Dombivli, India

Control Panels For Unclog Pumpsets, Control Panels For Dewatering Pumpsets, Control Panels For Hydro Pneumatic Pumpsets, Dombivli, India

Products 2

WELCOME

to our Neel Electronics & Electricals

IIT Control Panels

IIT Control Panels

>> Products

AUTOMATIC CONTROL PANEL FOR UNCLOG (DEWATERING) PUMPSET - TYPE B

* These pumps are basically used to drain the water from U. G. Tank or basement Pit etc.
* They can be used for effluent plants, Drainage & Sewage system, muddy water, Swimming Pools etc.
* Control Panel for dewatering system generally uses Float type sensors for level control, but can also be available in prodless Logic.
* Additional Cut-Off facility from thermister control which is embedded into motor windings.
* This panel can be hooked with Hydro pneumatic systems.
* Outdoor Panels are also available for this category.

AUTOMATIC CONTROL PANEL FOR HYDRO PNEUMATIC SYSTEMS - TYPE A

* Under this conceptual operations Overhead Tank is eliminated and instead pressurized chambers are used.

A typical use is as follows -

When, in such a pressurized system, a tap if opened will cause the pressure to drop. When such a drop goes below the set point, the stationary pump will go into operation and build up the pressure to desired level. The pump stops when upper
set point is reached. In case if load exceeding beyond the rated capacity of one pump, others will be put into use by default in sequence thereby maintaining desired pressure levels at all times. Also it ensures equal use of all pumps by discarding the
manual option.

The latest VFD (Variable Frequency Drive) Technology can also be incorporated in Panels to maintain constant pressure. This system works on soft start-soft stop logic where speed of the motor is directly proportional to frequency. Thus at lower
frequencies while maintaining the torque there is a drop in voltage thereby offering a heavy power saving.

* Single Phase / Three Phase option available.

Automatic Control Panel for Fire Fighting pumpsets

*	In this system the demand for water supply which may come anytime would be critical and crucial. Hence it gets subdivided into following sections. a. Fire Pumpset + Jocky Pumpset b. Sprinkler Pumpset + Jocky Pumpset c. Booster Pumpset
*	Jocky pumpset associated with Fire Pumpset / Sprinkler Pumpset online routinely. Whenever a minor drop in pressure is detected ( usually a result of improper closure or leakages) and brings up the pressure to desired level before switching itself OFF. In an emergency there is a drastic fall in pressure which will compell the fire Pumpset / Sprinkler Pumpset to go into operation. In the event of insufficient waterin UG Tank, Booster Pumpset using Overhead Tank (Emergency) can be pressed into service.
*	Hooter system which gives a shrill warning whenever any of these pumps go into operation.
*	Since the pumps are not regularly in use, there is a provision to check the mechanical or other performance using a manually bypass switch. This keeps the system " BATTLE READY" at all times.
*	These panels are generally equipped with a. switch Fuse Units (SFU) b. Busbar System c. HRC Back up d. MCCB (Optional)

User defined Control Panels for Industrial / Commercial Use

	Airport	Indl CP1	McDonalds	Pump Test Bench
*	These types of systems are specially designed according to the requirements of the User.
*	These types of Panels are designed for Automation of the systems installed at Residential, Commercial, and Industrial Zones.
*	We are proud to have supplied these type of Panels to McDonalds, Santacruz Airport, IIT Powai, etc. through our esteemed Dealers.

Designed & Hosted by : MID Promoted by : GID